Avaya WLAN 8100 Series Reference page 337

burst-size <4,8,16,...,16384>
max-burst-rate <64-4294967295>
max-burst-duration
<1-4294967295>
in-profile-action <1-55000>
in-profile-action-name <WORD>
out-profile-action <1,9-55000>
out-profile-action-name <word>
Removing QoS meter entries
About this task
Use the following procedure to delete QoS meter entries.
Note: A meter that is referenced in an installed policy or classifier block cannot be deleted.
Procedure
Remove QoS meter entries by using the following command from Global Configuration
mode.
no qos meter <1-55000>
Configuring QoS Interface Shaper
Related topics:
Configuring interface shaping
Disabling interface shaping
Avaya WLAN 8100 CLI Reference
Variable
on page 338
on page 338
Value
Kb/s for in-profile traffic in increments of 1000 Kbits/
sec; range is 64 to 10230000 Kbits/sec.
Committed burst size in Kilobytes. The value range is:
4, 8, 16, 32, 64, 128, 256, 512, 1024, 2048, 4096,
8192, 16384.
Specifies the largest burst of traffic that can be
received a given time for the traffic to be considered
in-profile. Used in calculating the committed burst size.
Enter the burst size in Kb/s for in-profile traffic; range
is 64 to 4294967295 Kbits/sec.
Specifies the amount of time that the largest burst of
traffic that can be received for the traffic to be
considered in-profile. Used in calculating the
committed burst size. Enter the burst duration in ms
for in-profile traffic; range is 1–4294967295 ms.
Specifies the in-profile action ID; range is 1–55000.
Specifies the in-profile action name.
Specifies the out-of-profile action ID; range is 1,9 to
55000.
Specifies the out of profile action name.
ACLI reference for wired networks
August 2013 337