Avaya WLAN 8100 Series Reference page 357

<1-65535>
Configuring IPFIX using CLI
The following sections describe the commands used in the configuration and management of
IP Flow Information Export (IPFIX) using the CLI.
Related topics:
Configuring IPFIX collectors
Enabling IPFIX globally
Configuring unit specific IPFIX
Enabling IPFIX on the interface
Enabling IPFIX export through ports
Deleting the IPFIX information for a port
Viewing the IPFIX table
Configuring IPFIX collectors
About this task
The ip ipfix collector command is used to configure IPFIX collectors. IPFIX collectors
are used to collect and analyze data exported from an IPFIX compliant switch. In WLAN
Release 1.1, the only external collector supported is NetQOS. At this time, up to two collectors
can be supported.
IPFIX data is exported from the switch in Netflow version 9 format. Data is exported using UDP
port 9995.
IPFIX data is not load balanced when two collectors are in use. Identical information is sent to
both collectors.
Use the following procedure to configure the IPFIX collectors.
Procedure
1. Enter Global Configuration mode.
2. Use the ip ipfix collector <unit_number> <collector_ip_address>
Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable
on page 357
on page 358
on page 360
command to configure the IPFIX collector.
Unique index for the statistics entry. If
omitted, all statistics are disabled.
on page 358
on page 359
on page 359
on page 359
ACLI reference for wired networks
Definition
August 2013 357