Configuring Elements, Classifiers, And Classifier Blocks - Avaya WLAN 8100 Series Reference

Variable
vlan-tag <vtag>
ethertype <etype>
priority <ieee1p_seq>
drop-action {drop | pass}
update-dscp <0 - 63>
update-1p <0 - 7>
set-drop-prec {high-drop |
low-drop}
block <block_name>
Removing a Layer 2 access list
About this task
Remove a Layer 2 access list by performing this procedure.
Procedure
Remove an access list by using the following command from Global Configuration
mode.
no qos l2-acl <aclid>

Configuring Elements, Classifiers, and Classifier Blocks

About this task
Use the CLI commands in this section to configure elements, classifiers, and classifier
blocks.
Related topics:
Configuring IP classifier element entries
Viewing IP classifier entries
Removing IP classifier entries
Adding Layer 2 elements
Viewing Layer 2 elements
Removing Layer 2 elements
Linking IP and L2 classifier elements
Avaya WLAN 8100 CLI Reference
Specifies the VLAN tag to use with this access list.
Specifies the Ethernet protocol type to use with the access
list.
Specifies the priority value to use with this access list.
Specifies the drop action to use for this access list.
Specifies the DSCP value to update for this access list.
Specifies the 802.1p value to update for this access list.
Specifies the drop precedence to configure for this access list.
Specifies the block name to associate with the access list.
on page 310
on page 311
on page 312
on page 312
on page 313
on page 314
on page 314
ACLI reference for wired networks
Value
August 2013 309