Avaya WLAN 8100 Series Reference page 294

ACLI Reference for wired networks
Variable
default
<1-3>
Configuring static mrouter ports on a VLAN
About this task
IGMP snoop considers the port on which the IGMP query is received as the active IGMP
multicast router (mrouter) port. By default, the switch forwards incoming IGMP Membership
Reports only to the active mrouter port.
To forward the IGMP reports to additional ports, you can configure the additional ports as static
mrouter ports.
Procedure
To configure static mrouter ports on a VLAN (IGMPv1, IGMPv2, and IGMPv3 according
to the supported version on the VLAN), enter the following from the VLAN Interface
Configuration mode:
[default] [no] ip igmp mrouter <portlist>
OR
To configure IGMPv1 or IGMPv2 static mrouter ports, enter the following from the
Global Configuration command mode:
[no] vlan igmp <vid> {v1-members | v2-members} [add | remove]
<portlist>
default
no
<portlist>
{v1-members | v2-members}
[add | remove]
Displaying IGMP snoop, proxy, and mrouter configuration
About this task
Use this procedure to display the IGMP snoop, proxy, and mrouter configuration per VLAN.
294 Avaya WLAN 8100 CLI Reference
Variable Definitions
Restores the default IGMP protocol version (IGMPv2).
Specifies the IGMP version.
Variable Definitions
Variable
Comments? infodev@avaya.com
Value
Value
Removes all static mrouter ports.
Removes the specified static mrouter port.
Specifies the list of ports to add or remove as static
mrouter ports.
Specifies whether the static mrouter ports are
IGMPv1 or IGMPv2.
Specifies whether to add or remove the static
mrouter ports.
August 2013