Avaya WLAN 8100 Series Reference page 149

CLI reference:
WCP8180(config)#ip default-gateway ?
A.B.C.D
The following table describes the parameters for the ip default-gateway command.
Table 7: ip default-gateway command parameters
Parameters
A.B.C.D
Note:
When the IP gateway is changed, connectivity to Telnet and the Web Interface can be
lost.
The show ip command displays the IP configurations, BootP/DHCP mode, switch address,
subnet mask, and gateway address. This command displays these parameters for what is
configured, what is in use, and the last BootP/DHCP.
This command is executed in the User EXEC command mode.
If you do not enter any parameters, this command displays all IP-related configuration
information.
CLI reference:
WCP8180(config)#show ip ?
Parameters:
address
bootp
default-gateway
<cr>
Sub-Commands/Groups:
arp-proxy
default-ttl
dhcp
dhcp-relay
directed-broadcast
dns
fwd-nh
igmp
ipfix
mgmt
route
routing
WCP8180(config)#
The following table describes the parameters for the show ip command.
bootp
Avaya WLAN 8100 CLI Reference
IP address of default gateway
Enter the dotted-decimal IP address of the default IP gateway.
show ip command
IP address of switch/stack
Show bootp settings
IP address of default gateway
Display Proxy ARP status
Display default TTL
Display DHCP settings
Display DHCP relay information
Display directed-broadcast forwarding mode
Display DNS configuration
Display IP forwarding next-hop settings
Display IGMP information
Display IPFIX settings
Display management VLAN information
Display IP route information
Display global routing enable/disable
Parameters
Description
Description
Displays BootP/DHCP-related IP information. The
possibilities for status returned are:
ACLI reference for wired networks
August 2013 149