Avaya WLAN 8100 Series Reference page 280

ACLI Reference for wired networks
Procedure
To display the static routes configured for the management VLAN, enter the following
from the User EXEC mode:
show ip mgmt route
Job aid
The following table shows the shows the field descriptions for the show ip mgmt route
command.
Destination IP
Subnet Mask
Gateway IP
Status
DHCP relay configuration using CLI
Before you begin
• Enable IP routing globally.
• Enable IP routing and configure an IP address on the VLAN to be set as the DHCP relay
agent.
• Ensure that a route to the destination DHCP server is available on the switch.
About this task
The following sections describe procedures you can use to configure DHCP relay using the
CLI.
Important:
DHCP relay uses a hardware resource that is shared by the switch Quality of Service
applications. When DHCP relay is enabled globally, the Quality of Service filter manager will
not be able to use precedence 11 for configurations.
Related topics:
DHCP relay configuration procedures
Configuring global DHCP relay status
Displaying the global DHCP relay status
Specifying a local DHCP relay agent and remote DHCP server
Displaying the DHCP relay configuration
280 Avaya WLAN 8100 CLI Reference
Field
Identifies the route destination.
Identifies the route mask.
Identifies the next hop in the route.
Identifies the status of the management route.
Comments? infodev@avaya.com
Description
on page 281
on page 281
on page 281
on page 283
on page 282
August 2013