Avaya WLAN 8100 Series Reference page 330

ACLI Reference for wired networks
Restoring egress mapping entries to default
About this task
Use the following procedure to reset the egress mapping entries to factory default values.
Procedure
Reset the entries by using the following command from Global Configuration mode.
default qos egressmap
Configuring 802.1p priority to DSCP
About this task
Use the following procedure to configure 802.1p priority-to-DSCP associations that are used
for assigning default values at packet ingress based on the 802.1p value in the ingressing
packet.
Procedure
1. Configure priority by using the following command from Global Configuration
2. vView the configured ingressmap details by using the following command:
Example
WCP8180(config)#show qos ingressmap
802.1p Priority DSCP
_______________ ____ ________________
0
1
2
3
4
5
6
7
Variable
name <WORD>
1p <0-7>
ds <0-63>
330 Avaya WLAN 8100 CLI Reference
mode.
qos ingressmap [name <WORD>] 1p <0-7> ds <0-63>
show qos ingressmap
Name
0 Standard Service
0 Standard Service
10 Bronze Service
18 Silver Service
26 Gold Service
34 Platinum Service
46 Premium Service
48 Network Service
Variable Definitions
Specifies the label for the ingress mapping.
Specifies the 802.1p priority used as lookup key for DSCP
assignment at ingress; range is between 0 and 7.
Specifies the DSCP value associated with the target 802.1p
priority; range is between 0 and 63.
Comments? infodev@avaya.com
Value
August 2013