Avaya WLAN 8100 Series Reference page 331

Restoring ingress mapping entries to default
About this task
Use the following procedure to reset the ingress mapping entries to factory default values.
Procedure
Reset the entries by using the following command from Global Configuration mode.
default qos ingressmap
Configuring QoS system-element
Related topics:
Configuring system classifier element parameters
Viewing system classifier elements parameters
Removing system classifier element entries
Configuring system classifier element parameters
About this task
Use the following procedure to configure system classifier element parameters that may be
used in QoS policies.
Procedure
Configure system classifier element parameters by using the following command from
Global Configuration mode.
qos system-element <1-55000> [known-ip-mcast | known-non-ip-
mcast | name | non-ip | pattern-data <WORD> | pattern-format
{tagged | untagged}] | [pattern-ip-version {ipv4 | ipv6 | non-
ip}] | pattern-l2–format | session-id | unknown-ip-mcast |
unknown-non-ip-mcast | unknown-ucast
<1-55000>
known-ip-mcast
known-non-ip-mcast
name
Avaya WLAN 8100 CLI Reference
Variable definitions
Variable
on page 331
on page 332
on page 333
Value
Specifies the system classifier element entry id; range
is 1–55000.
Matches the frames containing a known IP multicast
destination address.
Match frames containing a known non-IP multicast
destination address.
Specifies the name of the system element.
ACLI reference for wired networks
August 2013 331