Avaya WLAN 8100 Series Reference page 133

image-update
reset-group-size
WCP8180(config-wireless)#domain auto-promoted-aps ?
approve
WCP8180(config-wireless)#domain load-balance
WCP8180(config-wireless-lb)# ?
Load Balance configuration commands
controller
default
end
exit
lb-metric
no
WCP8180(config-wireless-lb)#lb-metric ?
least-load
location
WCP8180(config-wireless)#domain mobility-vlan ?
WORD Enter a mobility VLAN name (1-32 chars)
WCP8180(config-wireless)#domain wsp ?
H.H.H WSP MAC Address to create/modify a WSP entry in WSP database
About this task
Use this procedure to configure domain options:
Procedure
1. Enter Wireless Configuration mode of the CLI.
2. Use the command domain ap-client-qos to enable access point QoS
3. Use the command domain ap-reconnection-timeout to configure the AP-WCP
4. Use the command domain auto-promote-discovered-ap to enable auto
5. Use the command domain client-roam-agetime <1 - 120> to configure
6. Use the command domain country-code <country_code> to configure a
7. Use the command domain tspec-violation-report-interval <0 -
Avaya WLAN 8100 CLI Reference
Configure AP image update related parameters
Configure group size for a bulk RESET
approve all Discovered AP
Controller load balance configuration commands
Set load-balance parameters to default
End configuration mode
Exit from domain load-balance configuration mode
Load balance metric for both AP and WSP
Remove AP/WSP lb metrics
Load balance to the least loaded device
Load balance to the device in the nearest location(C.B.F.S)
operations for clients.
failover timeout.
promotion of discovered access points.
the client roaming timeout value in seconds.
country code for domain operation.
Note:
When creating an AP profile, specify a country code or use the default 'primary'
country code of the domain. To change the country code after you create the AP
profile, you must first delete the AP profile and then create a new profile. Multiple-
country domain names support a maximum of 32 countries.
900> to configure the TSPEC violators reporting interval in seconds.
ACLI reference for the Wireless LAN (WLAN) 8100
August 2013 133