Avaya WLAN 8100 Series Reference page 287

Static ARP and Proxy ARP configuration using CLI
About this task
Use the following procedures to configure Static ARP, Proxy ARP, and display ARP entries
using the CLI.
Related topics:
Static ARP configuration
Proxy ARP configuration
Static ARP configuration
About this task
This section describes how to configure Static ARP using the CLI.
About this task
Use this procedure to create and enable a static ARP entry.
Prerequisites
• Enable IP routing globally.
• Enable IP routing and configure an IP address on the target VLAN.
Procedure
To configure a static ARP entry, enter the following from the Global Configuration
mode:
[no] ip arp <A.B.C.D> <aa:bb:cc:dd:ee:ff> <port> [vid <1-4094>]
Variable Definitions
[no]
<A.B.C.D>
<aa:bb:cc:dd:ee:ff>
< port>
vid <1-4094>
Avaya WLAN 8100 CLI Reference
on page 287
on page 289
Configuring a static ARP entry
Variable Value
Removes the specified ARP entry.
Specifies the IP address of the device being set
as a static ARP entry.
Specifies the MAC address of the device being set
as a static ARP entry.
Specifies the port number to which the static ARP
entry is being added.
Specifies the VLAN ID to which the static ARP
entry is being added.
ACLI reference for wired networks
August 2013 287