Avaya WLAN 8100 Series Reference page 249

2. To set the STP BPDU Filtering properties on a port to their default values, use the
3. To show the current status of the BPDU Filtering parameters, use the following
port <portlist>
enable
timeout <10-65535| 0>
Creating and Managing STGs using the CLI
To create and manage Spanning Tree Groups, you can refer to the Command Line Interface
commands listed in this section. Depending on the type of Spanning Tree Group that you want
to create or manage, the command mode needed to execute these commands can differ.
In the following commands, the omission of any parameters that specify a Spanning Tree
Group results in the command operating against the default Spanning Tree Group (Spanning
Tree Group 1).
The following sections describe commands to configure and manage STGs using the CLI.
Related topics:
Configuring path cost calculation mode
Configuring STG port membership mode
Displaying STP configuration information
Creating a Spanning Tree Group
Deleting a Spanning Tree Group
Enabling a Spanning Tree Group
Disabling a Spanning Tree Group
Avaya WLAN 8100 CLI Reference
[no] spanning-tree bpdu-filtering [port<portlist>] [enable]
[timeout <10-65535> | 0>]
Use the no form of this command to disable.
following command from the Interface Configuration command mode:
default spanning-tree bpdu-filtering [port<portlist>]
[enable] [timeout]
command from the Privileged EXEC mode:
show spanning-tree bpdu-filtering [<interface-type>]
[port<portlist>]
Variable Definitions
Variable
Specifies the ports affected by the command.
Enables STP BPDU Filtering on the specified ports.
The default value is disabled.
When BPDU filtering is enabled, this indicates the
time (in seconds) during which the port remains
disabled after it receives a BPDU. The port timer is
disabled if this value is set to 0. The default value is
120 seconds.
on page 250
on page 250
on page 250
on page 251
on page 251
on page 251
on page 252
ACLI reference for wired networks
Value
August 2013 249