Avaya WLAN 8100 Series Reference page 290

ACLI Reference for wired networks
Procedure
To configure proxy ARP status, enter the following from the VLAN Interface
Configuration mode:
[default] [no] ip arp-proxy enable
Variable Definitions
Variable
default
no
About this task
Use this procedure to display the status of proxy ARP on a VLAN.
Procedure
To display proxy ARP status for a VLAN, enter the following from the User EXEC mode:
show ip arp-proxy interface [vlan<vid>]
Variable Definitions
Variable
<vid>
Job aid
The following table shows the field descriptions for the show ip arp-proxy
interfaces command.
Vlan
Proxy ARP status
IGMP snooping configuration using the CLI
About this task
Use the following procedures to configure IGMP snooping on a VLAN using the CLI.
290 Avaya WLAN 8100 CLI Reference
Disables proxy ARP functionality on the VLAN.
Disables proxy ARP functionality on the VLAN.
Displaying proxy ARP status on a VLAN
Specifies the ID of the VLAN to display. Range is 1-4094.
Field
Identifies a VLAN.
Specifies the status of Proxy ARP on the VLAN.
Comments? infodev@avaya.com
Value
Value
Description
August 2013