Avaya WLAN 8100 Series Reference page 172

ACLI Reference for wired networks
Displaying the current configuration
The show running-config command displays the current configuration of switch.
The syntax for the show running-config command is:
show running-config
This command only can be executed in the Privileged EXEC mode and takes no
parameters.
CLI reference:
WCP8180#show running-config ?
module
verbose
<cr>
Storing the current configuration
The copy running-config command copies the contents of the current configuration file
to another location for storage. For all switches in the 8100 Series, the configuration file can
be saved to a TFTP server. The WC 8180 also provide the ability to save the configuration file
to a USB Mass Storage Device through the front panel USB drive.
The syntax for the copy running-config command is:
copy running-config {tftp | (usb) [u2] } address <A.B.C.D> filename
<name>
The following table outlines the parameters for this command.
Table 24: copy running-config parameters
{tftp | usb}
address <A.B.C.D>
filename <name>
The copy running-config command only can be executed in the Privileged EXEC
mode.
copy tftp config command
Use this command to restore a configuration file stored on a TFTP server.
The syntax for this command is:
copy tftp config address <A.B.C.D> filename <name>
The following table outlines the parameters for this command.
172 Avaya WLAN 8100 CLI Reference
Display configuration of an application
Display entire configuration (defaults and non-defaults)
Parameters
Comments? infodev@avaya.com
Description
This parameter specifies the general location in which
the configuration file is saved.
If a TFTP server is to be used, this parameter signifies
the IP address of the server to be used.
The name of the file that is created when the
configuration is saved to the TFTP server or USB Mass
Storage Device.
August 2013