Avaya WLAN 8100 Series Reference page 156

ACLI Reference for wired networks
The no autotopology command disables the Autotopology protocol.
The syntax for the no autotopology command is: no autotopology
The no autotopology command is executed in the Global Configuration command mode.
The default autotopology command enables the Autotopology protocol.
The syntax for the default autotopology command is: default autotopology
The default autotopology command is executed in the Global Configuration command
mode.
The show autotopology settings command displays the global autotopology settings.
The syntax for the show autotopology settings command is: show autotopology
settings
The show autotopology settings command is executed in the Privileged EXEC
command mode.
The show autotopology nmm-table command displays the Autotopology network
management module (NMM) table.
The syntax for the show autotopology nmm-table command is: show autotopology nmm-
table
The show autotopology nmm-table command is executed in the Privileged EXEC
command mode.
Enabling flow control
About this task
Gigabit Ethernet, when used with the WC 8180, can control traffic on this port using the
flowcontrol command.
See the following commands to enable flow control using the CLI.
Related topics:
flow control command
no flowcontrol command
default flowcontrol command
default rate-limit command
156 Avaya WLAN 8100 CLI Reference
no autotopology command
default autotopology command
show autotopology settings command
show autotopology nmm-table command
on page 157
on page 157
on page 158
on page 158
Comments? infodev@avaya.com
August 2013