Avaya WLAN 8100 Series Reference page 322

ACLI Reference for wired networks
Globally enabling and disabling QoS Agent support
About this task
Perform this procedure to globally enable or disable QoS Agent support. The commands used
in this procedure are available in Global Configuration mode.
QoS Agent support is enabled by default. QoS Agent support cannot be disabled if QoS
functionality is currently used by NSNA or UBP.
Procedure
1. Globally enable QoS Agent support using the following command:
2. Globally disable QoS Agent support using the following commands:
Variable
enable
disable
Configuring a default queue set
About this task
Use the following procedure to specify the default queue set.
Note: The default qos agent command has the same result as the qos agent reset-default
command.
Procedure
Configure the queue set by using the following command from Global Configuration
mode.
default qos agent [aq-mode| buffer | dos-attack-prevention |
nvram-delay | oper-mode | queue-set | statistics-tracking |
ubp]
322 Avaya WLAN 8100 CLI Reference
qos agent oper-mode [enable]
OR
default qos agent [oper-mode]
qos agent oper-mode [disable]
OR
no qos agent oper-mode [enable]
Variable Definitions
Enables QoS Agent functionality for the system.
Disables QoS Agent functionality for the system.
Comments? infodev@avaya.com
Value
August 2013