Avaya WLAN 8100 Series Reference page 343

Destination MAC Addr: Ignore
Destination MAC Mask: Ignore
Source MAC Addr: Ignore
Source MAC Mask: Ignore
VLAN: Ignore
VLAN Tag: Ignore
EtherType: Ignore
802.1p Priority: All
Packet Type: Ignore
Action Drop: No
Action Update DSCP: Ignore
Action Update 802.1p Priority: Ignore
Action Set Drop Precedence: Low Drop
Out-Profile Drop Action: Drop
Out-Profile Update DSCP Action: Ignore
Out-Profile Set Drop Precedence Action: Low Drop
Storage Type: NonVolatile
Configuring User Based Policies
About this task
Use the following procedure to configure User Based Policies.
Procedure
Configure User Based Policies by using the following command from the Global
configuration mode.
qos ubp
To modify an entry in a filter set, you must delete the entry and add a new entry with
the desired modifications.
Variable Definitions
classifier name [addr-type {ipv4|
ipv6}] [block] [drop-action] [ds-field]
[dst-ip] [dst-mac] [dst-port-min]
[ethertype] [eval-order] [flow-id]
[next-header] [priority] [protocol]
[set-drop-prec] [src-ip] [src-mac]
[src-port-min] [update-1p] [update-
dscp] [vlan-min] [ vlan-tag]
Avaya WLAN 8100 CLI Reference
Note:
Variable Value
Creates the User Based Policy classifier entry.
Optional parameters:
• addr-type {ipv4|ipv6} specifies the type of IP address
used by this classifier entry. The type is limited to
IPv4 and IPv6 addresses.
• block specifies the label to identify access list
elements that are of the same block.
• drop-action specifies whether or not to drop non-
conforming traffic.
• ds-field specifies the value for the DiffServ
Codepoint (DSCP) in a packet.
ACLI reference for wired networks
August 2013 343