Avaya WLAN 8100 Series Reference page 152

ACLI Reference for wired networks
3. Use the command edm help-file-path <help-file-path> to set the EDM
Configuring the HTTP Port
About this task
Use the following procedure to configure the HTTP Port.
Procedure
1. Enter Privileged mode of the CLI.
2. Enter Configuration mode by entering the config command.
3. Use the command http-port <1024–65535> to set the HTTP port.
Setting port speed
See the following sections for CLI commands to configure port speed and duplexing.
Related topics:
speed command
default speed command
duplex command
default duplex command
The speed command sets the speed of the port.
The syntax for the speed command is: speed [port <portlist>] {10 | 100 | 1000
| auto}
The speed command is executed in the Interface Configuration command mode.
The following table describes the parameters for the speed command.
Table 9: speed command parameters
port <portlist>
10|100|1000|auto
152 Avaya WLAN 8100 CLI Reference
help file path.
on page 152
on page 153
on page 153
on page 154
speed command
Parameters
Comments? infodev@avaya.com
Description
Specifies the port numbers for which to
configure the speed. Enter the port numbers
you want to configure.
Note: If you omit this parameter, the system
uses the port number you specified in the
interface command.
Sets speed to:
August 2013