Avaya WLAN 8100 Series Reference page 328

ACLI Reference for wired networks
Variable
name <WORD>
class <trusted | untrusted
| unrestricted>
Removing an interface group
About this task
Use the following procedure to delete interface groups.
Note 1: An interface group referenced by an installed policy cannot be deleted.
Note 2: An interface group associated with ports cannot be deleted.
Procedure
Delete interface groups by using the following command from Global Configuration
mode.
no qos if-group name <WORD>
Configuring DSCP and 802.1p and Queue Associations
About this task
The following sections contain procedures to configure DSCP, 802.1p priority and queue set
associations.
Related topics:
Configuring DSCP to 802.1p priority
Restoring egress mapping entries to default
Configuring 802.1p priority to DSCP
Restoring ingress mapping entries to default
Configuring DSCP to 802.1p priority
About this task
Use the following procedure to configure DSCP-to-802.1p priority and drop precedence
associations that are used for assigning these values at packet egress, based on the DSCP
in the received packet.
328 Avaya WLAN 8100 CLI Reference
Variable Definitions
Specifies the name of the interface group; maximum is 32 US-
ASCII. Name must begin with a letter a..z or A..Z.
Defines a new interface group and specifies the class of traffic
received on interfaces associated with this interface group:
• trusted
• untrusted
• unrestricted
Comments? infodev@avaya.com
Value
on page 328
on page 330
on page 330
on page 331
August 2013