Avaya WLAN 8100 Series Reference page 177

inactive-timeout <0-60>
logging {none | access | failures | all}
[source-ip <1-50> <A.B.C.D> [mask
<A.B.C.D>] [source-ip <WORD>
default telnet-access command
The default telnet-access command sets the Telnet settings to the default values.
The syntax for the default telnet-access command is:
default telnet-access
The default telnet-access command is executed in the Global Configuration command
mode.
Setting boot parameters
The command outlined in this section is used for booting the switch as well as setting boot
parameters.
Related topics:
boot command
boot command
The boot command performs a soft-boot of the switch.
The syntax for the boot command is:
boot [default] [partial default]
The boot command is executed in the Privileged EXEC command mode.
The following table describes the parameters for the boot command.
Avaya WLAN 8100 CLI Reference
Parameters
on page 177
ACLI reference for wired networks
Description
Specify in minutes the duration for an
inactive session to be terminated.
Specify the events whose details you want to
store in the event log:
• none-do not save access events in the log
• access-save only successful access
events in the log
• failure-save failed access events in the log
• all-save all access events in the log
Specify the source IP address from which
connections are allowed. Enter the IP
address in dotted-decimal notation. Mask
specifies the subnet mask from which
connections are allowed; enter IP mask in
dotted-decimal notation.
August 2013 177