Avaya WLAN 8100 Series Reference page 203

enable
max-addrs
The default mac-security auto-learning command executes in the Interface
Configuration mode.
Configuring RADIUS
Configure RADIUS to perform authentication services for system users. For specific
configuration procedures, see the vendor documentation. In particular, ensure that you set the
appropriate Service-Type attribute in the user accounts as follows:
• for read-write access, Service-Type = Administrative
• for read-only access, Service-Type = NAS-Prompt
Related topics:
Configuring a RADIUS server
Enabling RADIUS password fallback
Viewing RADIUS information
Configuring a RADIUS server
In WLAN 8100, RADIUS servers are grouped into a profile, called the radius-profile. Multiple
Radius-profiles, up to 32, can be configured on a controller. In each radius-profile, up to 32
RADIUS servers (IPs) can be configured. A RADIUS server (IP) in two different radius-profiles
count as 2 servers. A total of 32 servers can be configured on a controller.
About this task
Use this procedure to configure RADIUS servers.
Procedure
1. Enter Global or Interface Configuration mode of the ACLI.
2. Configure a RADIUS server using the command radius server <host IP
3. Configure a RADIUS profile using the command radius profile <profile
Avaya WLAN 8100 CLI Reference
Parameters
on page 42
on page 206
Address>, where <host IP address> is the IP address of the primary RADIUS
server you want to configure.
name> type .
Description
Sets to default the auto-learning status for
the port. The default is disabled.
Sets to default the maximum number of
addresses the port learns. The default is 2.
on page 193
ACLI reference for wired networks
August 2013 203