Avaya WLAN 8100 Series Reference page 153

Note: Enabling and disabling autonegotiation for speed also enables and disables it for duplex
operation.When you set the port speed for autonegotiation, ensure that the other side of the
link is also set for autonegotiation.
The default speed command sets the speed of the port to the factory default speed.
The syntax for the default speed command is: default speed [port <portlist>]
The default speed command is executed in the Interface Configuration command mode.
The following table describes the parameters for this command.
port <portlist>
The duplex command specifies the duplex operation for a port.
The syntax for the duplex command is: duplex [port <portlist>] {full | half
| auto}
The duplex command is executed in the Interface Configuration command mode.
The following table describes the parameters for this command.
port <portlist>
full | half | auto
Avaya WLAN 8100 CLI Reference
Parameters
default speed command
Parameters
duplex command
Parameters
• 10—10Mb/s
• 100— 100 Mb/s
• 1000— 1000 Mb/s or 1GB/s
• auto— autonegotiation
Description
Specifies the port numbers to set the speed to factory
default. Enter the port numbers you want to set.
Note: If you omit this parameter, the system uses the
port number you specified in the interface
command.
Description
Specifies the port numbers for which to reset the
duplex mode to factory default values. Enter the port
number you want to configure. The default value is
autonegotiation.
Note: If you omit this parameter, the system uses the
ports you specified in the interface command.
Sets duplex to:
ACLI reference for wired networks
Description
August 2013 153