Avaya WLAN 8100 Series Reference page 240

ACLI Reference for wired networks
Procedure
To reset the management VLAN to default, use the following command from Global
Configuration mode.
default vlan mgmt
Creating a VLAN
About this task
Use the following procedure to create a VLAN. A VLAN is created by setting the state of a
previously nonexistent VLAN.
Procedure
To create a VLAN, use the following command from Global Configuration mode.
vlan create <1-4094> [name<line>] type {port | protocol-
ipEther2 | protocol-ipx802.3 | protocolipx802.2 | protocol-
ipxSnap | protocol-ipxEther2 | protocol-decEther2 | protocol-
snaEther2 | protocol-N etbios | protocol-xnsEther2 | protocol-
vinesEther2 | protocol-ipv6Ether2 | protocol-Userdef
<4096-65534>| protocol-RarpEther2}
Variable definitions
<1-4094>
name <line>
type
protocol-ipEther2
protocol-ipx802.3
protocol-ipx802.2
protocol-ipxSnap
protocol-ipxEther2
protocol-decEther2
protocol-snaEther2
protocol-Netbios
protocol-xnsEther2
240 Avaya WLAN 8100 CLI Reference
Variable
Comments? infodev@avaya.com
Value
Enter the number of the VLAN to create.
Enter the name of the VLAN to create.
Enter the type of VLAN to create:
• port - port-based
• protocol - protocol-based (see following list)
Specifies an ipEther2 protocol-based VLAN.
Specifies an ipx802.3 protocol-based VLAN.
Specifies an ipx802.2 protocol-based VLAN.
Specifies an ipxSnap protocol-based VLAN.
Specifies an ipxEther2 protocol-based VLAN.
Specifies a decEther2 protocol-based VLAN.
Specifies an snaEther2 protocol-based VLAN.
Specifies a NetBIOS protocol-based VLAN.
Specifies an xnsEther2 protocol-based VLAN.
August 2013