Avaya WLAN 8100 Series Reference page 277

[no] ip route <dest-ip> <mask> <next-hop> [<cost>] [disable]
[enable] [weight<cost>]
Variable
[no]
<dest-ip>
<mask>
<next-hop>
[<cost>]
[disable]
[enable]
[weight<cost>]
Displaying static routes
About this task
Use this procedure to display all static routes, whether these routes are active or inactive.
Procedure
1. To display a static route, enter the following command from the User EXEC mode:
2. To display an IP route, enter the following commands from the User EXEC
Example
WCP8180#show ip route static
===============================================================================
===============================================================================
DEST
-------------------------------------------------------------------------------
Avaya WLAN 8100 CLI Reference
Variable Definitions
Removes the specified static route.
Specifies the destination IP address for the route being
added. 0.0.0.0 is considered the default route.
Specifies the destination subnet mask for the route being
added.
Specifies the next hop IP address for the route being
added.
Specifies the weight, or cost, of the route being added. Range
is 1-65535.
Disables the specified static route.
Enables the specified static route.
Changes the weight, or cost, of an existing static route. Range
is 1-65535.
show ip route static
command mode:
show ip route [-s <subnet IP Address> <mask>]
show ip route <Subnet IP Address> —s [<subnet IP Address>
<mask>]
MASK
Value
Ip Static Route
NEXT COST PREF LCLNHOP STATUS ENABLE
ACLI reference for wired networks
August 2013 277