ACLI Reference for wired networks
priority
tagged-bpdu
multicast address
About this task
Use the following procedure to add a VLAN to a specified Spanning Tree Group.
Procedure
To add a VLAN to a STG, use the following command from Global Configuration
mode.
spanning-tree [stp <1-8>] add-vlan <1-4094>
About this task
Use the following procedure to remove a VLAN from a specified Spanning Tree Group.
Procedure
To remove a VLAN from a STG, use the following command from Global Configuration
mode.
spanning-tree [stp <1-8>] remove-vlan <1-4094>
About this task
Use the following procedure to set the Spanning Tree Protocol (STP) and multiple Spanning
Tree Group (STG) participation for the ports within the specified Spanning Tree Group.
Procedure
To configure STP and MSTG participation, use the following command from Interface
Configuration mode.
[no] spanning-tree [port <portlist>] [stp <1-8>] [learning
{disable | normal | fast}] [cost <1-65535>] [priority]
254
Avaya WLAN 8100 CLI Reference
Variable
Adding a VLAN to a STG
Removing a VLAN from a STG
Configuring STP and MSTG participation
Comments? infodev@avaya.com
Value
Sets spanning tree priority (in Hex); if 802.1T
compliant, this value must be a multiple of
0x1000.
Sets the tagging to the default value. The
default value for Spanning Tree Group 1
(default group) is untagged; the default for
the other groups is tagged.
Sets the spanning tree multicast MAC
address to the default.
August 2013