Avaya WLAN 8100 Series Reference page 14

ACLI reference for Wireless LAN (WLAN) 8100
that are used to set up the required configuration on the controller. If the controller is reset with
default-settings, the install utility automatically runs on boot up.
Important:
The WC 8180 Quick Configuration utility is supported in only the Overlay deployment.
The WC 8180 Quick Configuration utility guides you through steps to configure the following:
• Management interface and Wireless or System interface
• Basic SNMP-v2
• Trap-host configuration
• SNTP
• telnet
• Wireless client interfaces
• Mobility VLANs
• Mobility domains
• Network profile, AP profile, Radio Profile and Captive Portal profile configuration
• Wireless RADIUS server configuration
• License download
Before you begin
• Remove the WC 8180 device from its packaging. Ensure you have the following hardware
components and materials:
- Wireless Controller (WC) 8180 device
- console cable
Procedure
1. Power on the WC 8180.
2. When the WC 8180 is up, connect the console cable.
3. Verify that the baud rate and other console parameters are properly configured. You
14 Avaya WLAN 8100 CLI Reference
can view console parameters using the PuTTY application.
a. Open a PuTTY session.
b. On the left-hand-side tree view, click Serial.
c. Verify that the parameters are configured as follows:
Comments? infodev@avaya.com
August 2013