Avaya WLAN 8100 Series Reference page 292

ACLI Reference for wired networks
Configuring IGMP snooping on a VLAN
About this task
Enable IGMP snooping on a VLAN to forward the multicast data to only those ports that are
members of the group.
IGMP snooping is disabled by default.
Procedure
To enable IGMP snooping, enter the following from the VLAN Interface Configuration
command mode:
[default] [no] ip igmp snooping
OR
Enter the following from the Global Configuration command mode:
[default] vlan igmp <vid> [snooping {enable | disable}]
default
no
enable
disable
Configuring IGMP send query on a VLAN
About this task
Use this procedure to enable IGMP send query on a snoop-enabled VLAN. When IGMP
snooping send query is enabled, the IGMP snooping querier sends out periodic IGMP queries
that trigger IGMP report messages from the switch or host that wants to receive IP multicast
traffic. IGMP snooping listens to these IGMP reports to establish appropriate forwarding.
IGMP send query is disabled by default.
Prerequisites
• You must enable snoop on the VLAN.
Procedure
To enable IGMP send query, enter the following command from the VLAN Interface
Configuration mode:
ip igmp send-query
292 Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable
Disables IGMP snooping on the selected VLAN.
Disables IGMP snooping on the selected VLAN.
Enables IGMP snooping on the selected VLAN.
Disables IGMP snooping on the selected VLAN.
Comments? infodev@avaya.com
Value
August 2013