Avaya WLAN 8100 Series Reference page 342

ACLI Reference for wired networks
Procedure
1. Delete a Traffic Profile classifier by using the following command from the Global
2. Delete a Traffic Profile set by using the following command from the Global
Viewing filter descriptions
About this task
View filter descriptions by performing this procedure.
Procedure
1. View classifier entries by using the following commands from the Privileged EXEC
2. View the parameters for a specific set by using the following command from the
3. View ports and the filter sets assigned to those ports by using the following
Example
Wc#show qos traffic-profile classifier name 1
Id: 2
Name: 1
Block:
Master: No
Eval Order: 1
Address Type: Ignore
Destination Addr/Mask: Ignore
Source Addr/Mask: Ignore
DSCP: Ignore
IPv4 Protocol / IPv6 Next Header: Ignore
Destination L4 Port Min: Ignore
Destination L4 Port Max: Ignore
Source L4 Port Min: Ignore
Source L4 Port Max: Ignore
IPv6 Flow Id: Ignore
IP Flags: Ignore
TCP Control Flags: Ignore
IPv4 Options: Ignore
342 Avaya WLAN 8100 CLI Reference
Configuration mode.
no qos traffic-profile classifier name <classifier-name>
Configuration mode.
no qos traffic-profile set {name <name> | port <port>}
Configuration mode.
show qos traffic-profile classifier
OR
show qos traffic-profile classifier name <classifier name>
Privileged EXEC Configuration mode.
show qos traffic-profile set <set name> port <port>
command from the Privileged EXEC Configuration mode.
show qos traffic-profile interface
Comments? infodev@avaya.com
August 2013