Avaya WLAN 8100 Series Reference page 189

4. Use the command ui-button enable to enable the ui-button feature.
Configuring USB Host Port
About this task
Use the following procedure to configure the USB host port.
Procedure
1. Enter Privileged mode of the CLI.
2. Enter Configuration mode by entering the config command.
3. Use the command usb-host-port enable to enable the usb host port.
Enabling Autosave
About this task
With autosave enabled the system checks every minute to see if there is any new configuration
data. If there is, it will automatically be saved to NVRAM. While autosave is enabled, the AUR
feature should perform normally.
Use the following command to enable the autosave feature.
autosave enable command
The autosave enable command is used to enable the autosave feature.
The syntax for this command is:
autosave enable
The autosave enable command is executed in Global Configuration command mode.
Setting the server for Web-based management with CLI
You can use the CLI to enable or disable a web server for use with Web-based
management.
Related topics:
web-server command
no web-server command
Avaya WLAN 8100 CLI Reference
on page 190
on page 190
ACLI reference for wired networks
August 2013 189