Managing Rstp Using The Cli - Avaya WLAN 8100 Series Reference

ACLI Reference for wired networks
Variable Definitions
port <portlist>
stp <1-8>
learning
cost
priority
About this task
Use the following command to configure RSTP:
• Configuring RSTP parameters
• Configuring RSTP on a port
• Displaying RSTP configuration
• Displaying RSTP port configuration
Configuring RSTP parameters
About this task
Use the following procedure to set the RSTP parameters which include forward delay, hello
time, maximum age time, default path cost version, bridge priority, transmit holdcount, and
version for the bridge.
Procedure
To configure RSTP parameters, use the following command from Global Configuration
mode.
spanning-tree rstp [ forward-time <4-30>] [hello-time <1-10>]
[max-age <6-40>] [pathcost-type {bits16 | bits32}] [priority
256 Avaya WLAN 8100 CLI Reference
Variable

Managing RSTP using the CLI

Comments? infodev@avaya.com
Enables spanning tree for the specified port or ports;
enter port or ports to be set to factory spanning tree
default values.
Note: If this parameter is omitted, the system uses
the port number specified when the interface
command was used to enter Interface Configuration
mode.
Specifies the Spanning Tree Group to set to factory
default values; enter the STG ID. This command
places the port into the default STG. The default
value for STG is 1.
Sets the spanning tree learning mode to the factory
default value.
The default value for learning is Normal mode.
Sets the path cost to the factory default value.
The default value for path cost depends on the type
of port.
Sets the priority to the factory default value.
The default value for the priority is 0x8000.
on page 256
on page 258
on page 258
on page 257
Value
August 2013