Avaya WLAN 8100 Series Reference page 106

ACLI reference for Wireless LAN (WLAN) 8100
6. Configure the Rogue AP detection interval.
7. Configure the Rogue client detection interval.
8. Configure the wired detection interval of a rogue AP.
9. Acknowledge Rogue clients/Rogue APs.
10. Enable RF Scan options.
106 Avaya WLAN 8100 CLI Reference
The default for the adhoc-clients, ap-failure and rf-scan ageout time is
1440 minutes. The default for the detected-clients ageout time is 300
minutes.
WCP8180(config-security)#wids ageout adhoc-clients ?
<0-10080> Time in minutes
WCP8180(config-security)#wids ageout ap-failure ?
<0-10080> Time in minutes
WCP8180(config-security)#wids ageout detected-clients ?
<0-10080> Time in minutes
WCP8180(config-security)#wids ageout rf-scan ?
<0-10080> Time in minutes
WCP8180(config-security)#wids rogue-ap trap-interval ?
<60-3600> Interval in seconds
Use the following command to set the default interval.
WCP8180(config-security)#default wids rogue-ap trap-interval
WCP8180(config-security)# wids rogue-client trap-interval ?
<60-3600> Interval in seconds
Use the following command to set the default interval.
WCP8180(config-security)#default wids rogue-client trap-interval
WCP8180(config-security)#wids rogue-ap wired-detection-interval ?
<1-3600> Interval in seconds
Use the following command to set the default interval.
WCP8180(config-security)#default wids rogue-ap wired-detection-interval
Acknowledge a specific Rogue AP (by specifying its MAC address) or all Rogue
APs.
WCP8180(config-security)#wids rogue-ap ack ?
all All rogue APs
H.H.H MAC Address of specific rogue AP
Acknowledge a specific Rogue client (by specifying its MAC address) or all Rogue
Clients.
WCP8180(config-security)#wids rogue-client ack ?
all All rogue clients
H.H.H MAC Address of specific rogue client
The WIDS/WIPS functionality is driven by a process called RF Scan where APs
with radios configured for WIDS/WIPS or just the WIDS functionality, scan radio
bands/channels to collect information about neighboring APs and detected clients
in those bands/channels. They then send this information to their managed WLAN
switches over UDP.
Comments? infodev@avaya.com
August 2013