Displaying an IGMP profile
About this task
Use this procedure to display an IGMP profile.
Procedure
To display an IGMP profile enter the following command from Global Configuration
mode:
show ip igmp profile <cr> or <profile number>
The following table shows the field descriptions for the show ip igmp profile
command.
Profile
Type
Range Start
Range End
Port List
Matched Grps
Configuring Access Lists
Use the CLI commands in this section to configure and manage Access Lists.
Related topics:
Assigning ports to an access list
Removing an access list assignment
Creating an IP access list
Removing an IP access list
Creating a Layer 2 access list
Removing a Layer 2 access list
Assigning ports to an access list
About this task
Assign ports to an access list by performing this the procedure.
Avaya WLAN 8100 CLI Reference
Job aid
Field
on page 306
on page 307
on page 308
Description
Indicates the profile ID of the IGMP.
Allows or denies rule for IGMP profile.
Indicates the IGMP Multicast start address.
Indicates the IGMP Multicast end address.
Specifies the type of port as blocked or static.
Specifies the matching profile for IGMP group.
on page 305
on page 306
on page 309
ACLI reference for wired networks
August 2013
305