Avaya WLAN 8100 Series Reference page 338

ACLI Reference for wired networks
Configuring interface shaping
About this task
Use the following procedure to configure interface shaping.
Procedure
Configure interface shaping by using the following command from Interface
Configuration mode.
qos if-shaper [port <portlist>] [name <WORD>] shape-rate
<64-10230000> {burst-size <burst-size> max-burst-rate
<64-4294967295> [max-burst-duration <1-4294967295>]}
burst-size <4,8,16, ..., 16384>
port <portlist>
name <WORD>
shape-rate <64-10230000>
max-burst-rate <64-4294967295>
max-burst-duration
<1-4294967295>
Disabling interface shaping
About this task
Use the following procedure to disable interface shaping.
Procedure
Disable interface shaping by using the following command from Interface Configuration
mode.
338 Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable
Comments? infodev@avaya.com
Value
Specifies the committed burst size in Kilobytes. The
value range is: 4, 8, 16, 32, 64, 128, 256, 512, 1024,
2048, 4096, 8192, 16384.
Specifies the ports to configure shaping parameters.
Specifies name for if-shaper; maximum is 16
alphanumeric characters.
Specifies the shaping rate in kilobits/sec; range is
64-10230000 kilobits/sec.
Specifies the largest burst of traffic that can be
received a given time for the traffic to be considered
in-profile. Used in calculating the committed burst size.
Enter the burst size in Kb/s for in-profile traffic; range
is 64 to 4294967295 Kbits/sec.
Specifies the amount of time that the largest burst of
traffic that can be received for the traffic to be
considered in-profile. Used in calculating the
committed burst size. Enter the burst duration in ms
for in-profile traffic; range is 1–4294967295 ms.
August 2013