Avaya WLAN 8100 Series Reference page 148

ACLI Reference for wired networks
Note:
When the IP address or subnet mask is changed, connectivity to Telnet and the Web can
be lost.
If you want to automatically obtain an IP address, subnet mask and default gateway, you can
use the ip address command with the source parameter. When you use DHCP, the switch
can also obtain up to three DNS server IP addresses.
Execute the ip address source command in the Global Configuration command mode.
CLI reference:
WCP8180(config)#ip address source ?
bootp-always
bootp-last-address
bootp-when-needed
configured-address
dhcp-always
dhcp-last-address
dhcp-when-needed
The following table describes the variables for the ip address source command:
Table 6: ip address source command parameters
bootp-always
bootp-last-address
bootp-when-needed
dhcp-always
dhcp-last-address
dhcp-when-needed
The no ip address command clears the IP address and subnet mask for a switch. This
command sets the IP address and subnet mask for a switch to all zeros (0).
The syntax for the no ip address command is: no ip address switch
The no ip address command is executed in the Global Configuration command mode.
Note: When the IP address or subnet mask is changed, connectivity to Telnet and the Web
Interface can be lost. Any new Telnet connection can be disabled and is required to connect
to the serial console port to configure a new IP address.
The ip default-gateway command sets the default IP gateway address for a switch to use.
This command is executed in the Global Configuration command mode.
148 Avaya WLAN 8100 CLI Reference
ip address source command
Always use the bootp server
Use the last time bootp server
Use bootp server when needed
User-configured IP address
Always use the DHCP server
Use the last time DHCP server
Use DHCP client when needed
Parameter
no ip address command
ip default-gateway command
Comments? infodev@avaya.com
Description
Always use the bootp server.
Use the last bootp server.
Use bootp server when needed.
Always use the DHCP server.
Use the last DHCP server.
Use DHCP client when needed.
August 2013