Add/Edit A Vendor Id Based Vlan; Port-Based Vlan Setup - ZyXEL Communications XMG1915 Series User Manual

48.8.1 Add/Edit a Vendor ID Based VLAN

Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN > Vendor ID Based VLAN
Setup to see this screen.
Figure 198 SWITCHING > VLAN > Vendor ID Based VLAN Setup > Add/Edit
The following table describes the fields in the above screen.
Table 153 SWITCHING > VLAN > Vendor ID Based VLAN Setup > Add/Edit
LABEL
Name
MAC Address
Mask
VID
Priority
Weight
Apply
Clear
Cancel

48.9 Port-Based VLAN Setup

Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Chapter 48 VLAN
DESCRIPTION
Enter a name up to 32 alphanumeric characters except [ ? ], [ | ], [ ' ], or [ " ] for the vendor
ID based VLAN entry.
Enter a MAC address that is bind to the vendor ID-based VLAN entry. This is the source MAC
address of the data packet that is looked up when untagged packets arrive at the Switch.
Enter the mask for the specified source MAC address to determine which bits a packet's
MAC address should match.
Enter "f" for each bit of the specified MAC address that the traffic's MAC address should
match. Enter "0" for the bits of the matched traffic's MAC address, which can be of any
hexadecimal characters. For example, if you set the MAC address to 00:13:49:00:00:00 and
the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this
criteria.
Enter an ID (from 1 to 4094) for the VLAN that is associated with the vendor ID based VLAN
entry.
Select the priority level that the Switch assigns to frames belonging to this VLAN. The higher
the numeric value you assign, the higher the priority for this vendor ID based VLAN entry.
Enter a number between 0 and 255 to specify the rule's weight. This is to decide the priority
in which the rule is applied. The higher the number, the higher the rule's priority.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1915 Series User's Guide
278