Vlan Port Setup - ZyXEL Communications XGS2220 Series User Manual

30/54-port gbe/sfp smart managed layer-3 switch

Table of Contents

Table 200 SWITCHING > VLAN > VLAN Setup > Static VLAN > Add/Edit (continued)

VLAN Group ID

56.5 VLAN Port Setup

Use this screen to configure the static VLAN (IEEE 802.1Q) settings on a port. Click SWITCHING > VLAN >

VLAN Setup > VLAN Port Setup to display the screen as shown.

Chapter 56 VLAN

Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.

Note: Do NOT add a VLAN ID that has been used in the SWITCHING > VLAN > Voice

The port number identifies the port you are configuring.

Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row first to set

the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Select Normal for the port to dynamically join this VLAN group using GVRP. This is the default

Select Fixed for the port to be a permanent member of this VLAN group.

Select Forbidden if you want to prohibit the port from joining this VLAN group.

Select Tx Tagging if you want the port to tag all outgoing frames transmitted with this VLAN

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to save

your changes to the non-volatile memory when you are done configuring.

Click Clear to clear the fields to the factory defaults.

Click Cancel to not save the configuration you make and return to the last screen.

XGS2220 Series User's Guide