Show Ipv6 Pim Interface - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
82-20

show ipv6 pim interface

This command is used to display the configuration for Protocol Independent Multicast (PIM) on
interface(s).
show ipv6 pim interface sparse-mode [INTERFACE-ID] [detail]
Parameters
INTERFACE-ID
detail
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to check if PIM is enabled on an interface, the number of neighbors, and the
designated router (DR) on the interface. If no interface is specified, the IPv6 PIM information on for all
applicable interfaces will be shown.
Example
This example shows how to display how to display the information of the PIM sparse mode interface.
Switch#show ipv6 pim interface sparse-mode
PIM6-SM Interface Table
Interface
------------
vlan1
Address
Global Address
DR
vlan2
Address
Global Address
DR
Total Entries : 2
Switch#
This example shows how to displays the PIM information on the interface VLAN 1 in detail.
Switch# show ipv6 pim interface sparse-mode vlan1 detail
Interface
(Optional) Specifies an interface for display
(Optional) Specifies to display interface information in detail.
Mode Nbr DR
Count Priority
------ ----- ----------
Sparse 1 1
:fe80::207:e9ff:fe02:81d
:3ffe:192:168:1::53
:fe80::20e:cff:fe01:facc
Sparse 2 1
: fe80::207:e9ff:fe02:21a2
: 3ffe:192:168:10::53
: this system
Hello J/P
Interval Interval
-------- --------
30 60
30 60 disabled
: vlan1
1026
BSR
Border
--------
enabled