D-Link DXS-3600 Series Cli Reference Manual page 1328

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
DOT1Q-VLAN
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If this command is configured, when the untagged packets are received on the 802.1Q tunnel port, the
specified dot1q VLAN tag will be inserted into it as inner tag.
Example
This example shows how to configure an interface port 1 to insert the inner tag with VLAN 10.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# switchport mode dot1q-tunnel
Switch(config-if)# dot1q-tunnel insert dot1q-tag 10
Switch(config-if)#
115-6 vlan mapping miss drop
This command is used to enable the dropping of VLAN mapping unmatched packets. Use the no
command to disable the VLAN mapping miss dropping.
vlan mapping miss drop
no vlan mapping miss drop
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port and port-channel interfaces that are set to 802.1Q tunnel
mode. If the VLAN mapping miss dropping option is enabled on the receiving port, when the original
Specifies the dot1q VLAN ID that is inserted to the untagged packets
which are received on the dot1q tunnel port.
1323