D-Link DXS-3600 Series Cli Reference Manual page 1023

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Suppression Time to prevent a possible negative value in the setting of the Register-Stop Timer. The
minimal value for Register Suppression Time is 3.
Example
This example shows how to configure the register suppression time to 30 seconds.
Switch# configure terminal
Switch(config)# ipv6 pim register-suppression 30
Switch(config)#
82-12 ipv6 pim rp embedded
This command is used to enable embedded RP support in PIMv6. Use the no command to disable
embedded RP support.
ipv6 pim rp embedded
no ipv6 pim rp embedded
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only takes effect when the interface is PIM-SM enabled.
Embedded RP defines an address allocation policy in which the address of the RP is encoded in an IPv6
multicast group address. This allows an easy deployment of scalable inter-domain multicast and simplifies
the intra-domain multicast configuration as well. IPv6 Multicast group addresses embedded with RP
information start with ff70::/12 where the flag value of 7 means embedded RP.
Because embedded RP support is enabled by default, the no form of this command is generally used,
which turns off embedded RP support. The ipv6 pim rp embedded command applies only to the
embedded RP group ranges ff7x::/12.
Example
This example shows how to disable embedded RP support in IPv6 PIM-SM.
Switch# configure terminal
Switch(config)# no ipv6 pim rp embedded
Switch(config)#
82-13 ipv6 pim rp-address
This command is used to configure the address of a PIM RP for a particular group range. Use the no form
of this command to remove an RP address.
1018