D-Link DXS-3600 Series Cli Reference Manual page 542

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
43-4 gvrp advertise
This command is used to specify the VLAN that are allowed to be advertised by the GVRP protocol. Use
the no command to disable the VLAN advertisement function.
gvrp advertise {all | [add | remove] VLAN-ID [, | -]}
no gvrp advertise
Parameters
all
add
remove
VLAN-ID [,|-]
,
-
Default
By default, no VLANs are advertised.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for both physical ports and port-channel interface configuration. Administrators
can use the gvrp advertise command to enable the specified VLANs' GVRP advertise function on the
specified interface. The command only takes effect when GVRP is enabled. The command only takes
effect for hybrid mode and trunk mode.
Example
This example shows how to enable the advertise function of VLAN 1000 on interface Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# gvrp advertise 1000
Switch(config-if)#
43-5 gvrp vlan create
This command is used to enable dynamic VLAN creation. Use the no command to disable the dynamic
VLAN creation function.
Specifies that all VLANs are advertised on the interface.
(Optional) Specifies a VLAN or a list VLANs to be added to advertise
the VLAN list.
(Optional) Specifies a VLAN or a list VLANs to be removed from the
advertised VLAN list.
(Optional) Specified the advertise VLAN list or the VLAN list to be
added to or removed from the advertise VLAN list. If the add or
remove parameter is not specified, the specified VLAN list overwrites
the advertise VLAN list. The range is 1 to 4094.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No spaces are required before and after the
comma.
(Optional) Specifies a range of VLANs. No spaces are required before
and after the hyphen.
537