D-Link DXS-3600 Series Cli Reference Manual page 1038

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-if)# ip pim sparse-mode
Switch(config-if)#
83-2 ip pim bsr-border
This command is used to configure the avoidance of sending and receiving BSR messages through an
interface. Use the no command to allow the message.
ip pim bsr-border
no ip pim bsr-border
Parameters
None.
Default
By default, this feature is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command only takes effect when the interface is PIM enabled. Use this command on the interface
that border with another domain to avoid the exchange of BSR messages across two domains.
Example
This example shows how to configure VLAN 100 as a BSR border interface.
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ip pim bsr-border
Switch(config-if)#
83-3 ip pim bsr-candidate
This command is used to configure the router to announce itself as the Candidate Bootstrap Router
(CBSR). Use the no form of this command to disable this router to act as a CBSR.
ip pim bsr-candidate INTERFACE-ID [HASH-MASK-LENGTH [PRIORITY]] [interval SECONDS]
no ip pim bsr-candidate
Parameters
INTERFACE-ID
HASH-MASK-LENGTH
Specifies the interface whose IP address will be announced as the
bootstrap router address.
Specifies to configure the hash mask length for RP selection. The
1033