D-Link DXS-3600 Series Cli Reference Manual page 1275

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
VLAN-ID
,
-
Default
None.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A sub-VLAN is a Layer 2 broadcast domain. This command is used to configure the sub-VLANs of a
super VLAN. A sub-VLAN can only belong to one super VLAN. Private VLANs and Super VLANs are
mutually exclusive.
Example
This example shows how to configure VLANs 5, 6 and 7 as the sub-VLANs of the super VLAN 10.
Switch# configure terminal
Switch(config)# vlan 10
Switch(config-vlan)# supervlan
Switch(config-vlan)# subvlan 5-7
Switch(config-vlan)#
106-3 subvlan-address-range
This command is used to configure the IP address range of a sub-VLAN. Use the no command to remove
the IP address range of a sub-VLAN.
subvlan-address-range START-IP-ADDRESS END-IP-ADDRESS
no subvlan-address-range [START-IP-ADDRESS END-IP-ADDRESS]
Parameters
START-IP-ADDRESS
END-IP-ADDRESS
Default
None.
Command Mode
Specifies the ID of the VLAN as a sub-VLAN. The valid VLAN ID range
is from 1 to 4094.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is required before and after the
comma.
(Optional) Specifies a range of VLANs. No space is required before
and after the hyphen.
Specifies the start IP address of this sub-VLAN.
Specifies the end IP address of this sub-VLAN.
1270