D-Link DXS-3600 Series Cli Reference Manual page 1176

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to display the RIP configuration information.
Switch# Show ipv6 rip
IPv6 RIP process , port 521, multicast-group FF02::9
Administrative distance is 25.
Maximum paths is 4
Updates every 60 seconds, expire after 180
garbage collect after 240
Split horizon is on; poison reverse is off
Periodic updates 8883, trigger updates 2
Interfaces:
VLAN 100
Redistribution:
Redistributing protocol static with metric 10
Switch#
94-10 split-horizon
This command is used to enable the split-horizon option for an IPv6 RIP process. Use the no form of the
command to disable the split-horizon option.
split-horizon
no split-horizon
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable split horizon mechanism in the IPv6 RIP routing update. When split horizon
is enabled, the routes learned from an interface will be not advertised out to the same interface.
Example
This example shows how to disable split-horizon for IPv6 RIP.
Switch# configure terminal
Switch(config)# ipv6 router rip
Switch(config-rtr)# no split-horizon
Switch(config-rtr)#
1171