Virtual Private Wire Service (Vpws) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
118. Virtual Private Wire Service (VPWS)
Commands
118-1 addition ac vlan
This command is used to configure the addition VLAN of the AC. Use the no command to delete the
addition vlan.
addition ac vlan VLAN-ID
no addition ac vlan
Parameters
VLAN-ID
Default
None.
Command Mode
Xconnect Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the addition VLAN for Ethernet VLAN-based ACs. The ingress
packets on the port with the addition VLAN ID can also be sent to the PW as the packets ingress on the
AC.
Example
This example shows how to configure the addition VLAN of the AC.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls
Switch(config-if-xconn)# addition ac vlan 20
Switch(config-if-xconn)#
118-2 backup peer
This command is used to create the PW redundancy of VPWS on the interface. Use the no command to
cancel the Pseudo-Wire (PW) redundancy of the VPWS service.
backup peer IP-ADDRESS VC-ID [delay {DISABLE-DELAY | never}]
no backup peer IP-ADDRESS VC-ID
Parameters
Specifies the addition VLAN ID.
1364