D-Link DXS-3600 Series Cli Reference Manual page 1027

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command only affects IPv6 PIM-SM. This command is used to configure the keep-alive timer, which
is the period during which the PIM router will maintain the (S, G) state in the absence of explicit (S, G)
local membership or (S, G) join messages received to maintain it.
Example
This example shows how to configure the (S, G) keep-alive time to 300 seconds.
Switch# configure terminal
Switch(config)# ipv6 pim sg-keepalive-time 300
Switch(config)#
82-17 show ipv6 pim
This command is used to display the PIM global information.
show ipv6 pim sparse-mode
Parameters
None.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the global information of PIM.
Example
This example shows how to display PIM global information.
Switch# show ipv6 pim sparse-mode
Register checksum wholepkt
Register probe time
Register suppression time
SPT Threshold
(S,G) keepalive time
Embedded RP support
RP Address
3ffe:6000:3000::123, group-list: G1
RP Candidate
vlan100, group-list: rp-cand, interval: 60, priority: 192
: Enabled
: 10 seconds
: 60 seconds
: Infinity
: 300 seconds
: Enabled
1022