D-Link DXS-3600 Series Cli Reference Manual page 1070

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
The routing table gathers routes learned from different protocols. If multiple routes can reach the same
network, the one with the best distance and the next hop is reachable will be chosen as the best and set
to hardware for routing of packets. They are the route entry currently at work. That is, if the route with the
best distance is with the unreachable next hop, then the route with the next preferred distance will be
chosen.
Example
This example shows how to display the routing table.
Switch# show ip route
Code: C - connected, S - static, R - RIP, B - BGP, I - IS-IS, O - OSPF,
IA - OSPF inter area,
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2,
E1 - OSPF external type 1, E2 - OSPF external type 2,
* - candidate default
Gateway of last resort is not set
C 10.0.0.0/8 is directly connected, vlan1
Total Entries: 1
Switch#
Display Parameters
Code
Sub Code
*
^
>
Indicates the source type that the route is derived from. It can be one
of the following values:
C - Connected.
S - Static.
R - Routing Information Protocol (RIP) derived.
B - Border Gateway Protocol (BGP) derived.
I – IS-IS derived.
O - Open Shortest Path First (OSPF) derived.
C - Connected.
The type of route. It can be one of the following values:
IA - OSPF interarea route.
E1 - OSPF external type 1 route.
E2 - OSPF external type 2 route.
N1 - OSPF not-so-stubby area (NSSA) external type 1 route.
N2 - OSPF NSSA external type 2 route.
The candidate default.
The next hop is reachable.
The route with the best distance among routes learned from multiple
protocols.
1065