D-Link DXS-3600 Series Cli Reference Manual page 1168

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The default update time: 30 seconds.
The default invalid time: 180 seconds.
The default flush time: 120 seconds.
Command Mode
Router Configuration Mode.
Router Address Family Configuration (RIP) Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to modify the RIP protocol timers.
Example
This example shows how to configure the RIP timers. Timers of update, invalid, and flush timers are set to
10, 80, and 160 respectively.
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# timers basic 10 80 160
Switch(config-router)#
93-16 version
This command is used to specify a RIP version globally as the default version for all interfaces. Use the
no form of the command to revert to the default setting.
version {1 | 2}
no version
Parameters
1
2
Default
By default, RIP version 1 and 2 packets are received, but only RIP version 1 packets are sent.
Command Mode
Router Configuration Mode.
Router Address Family Configuration (RIP) Mode.
Command Default Level
Level: 12.
Usage Guideline
This command defines the default RIP version. This version will be overridden if the version is explicitly
specified for the interface by using the ip rip send version and ip rip receive version commands.
Example
Specifies to only receive and transmit RIP version 1 packets.
Specifies to only receive and transmit RIP version 2 packets.
1163