D-Link DXS-3600 Series Cli Reference Manual page 1289

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
DESTINATION-URL
LOCATION
USER-NAME
PASSWORD
VRF-NAME
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to copy a file to another file in the file system. Use this command to download or
upload the configuration file or the image file. Use this command to upload the system log to the TFTP
server. To upload the running configuration or save the running configuration to the startup configuration,
specify running-config as the SOURCE-URL. To save the running configuration to the startup
configuration, specify startup-config as the DESTINATION-URL.
As the destination is the startup configuration, the source file is directly copied to the file specified in the
boot config command. Thus the original startup configuration file will be overwritten.
To apply a configuration file to the running configuration, specify running-config as the DESTINATION-
URL for the copy command and the configuration file will be executed immediately by using the
increment method. That means that the specified configuration will merge with the current running
configuration. The running configuration will not be cleared before applying of the specified configuration.
As the specified source is the system log and the specified destination is a URL, the current system log
will be copied to the specified URL.
To represent a file in the remote TFTP server, the URL must be prefixed with "tftp: //".
To download the firmware image, the user should use the copy tftp: // command to download the file
from the TFTP server to a file in the file system. Then, use the boot image command to specify it as the
boot image file.
Example
is to upload one unit's attack log.
Specifies the destination URL for the copied file. One special form of
the URL is represented by the following keywords.
If running-config is specified as the DESTINATION-URL, the purpose
is to apply a configuration to the running configuration.
If startup-config is specified as the DESTINATION-URL, the purpose
is to save a configuration to the next-boot configuration. That is to keep
the current configuration into the NVRAM and the file name will be the
same as the file name specified with the boot config command.
If flash: [PATH-FILE-NAME] is specified as the DESTINATION-URL,
the purpose is to specify the copied file in the file system. If the input
relative path is specified, the file will be downloaded to all units in stack
and stored in the current path of each unit. If the input absolute path is
specified, the file will be downloaded to the place which of the absolute
path indicates. If there is no unit information in the absolute path, the
master unit will be assigned.
Specifies the IPv4 address or IPv6 address of the TFTP/FTP/RCP
server.
Specifies the user name on the FTP/RCP server.
Specifies the password for the user.
Specifies the name of the VRF instance which the TFTP/FTP/RCP
server belongs to.
1284