D-Link DXS-3600 Series Cli Reference Manual page 1264

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
dot1ad
Default
By default, the Customer Bridge Group Address is used as the destination address of the STP BPDU.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Generally, the Customer Bridge Group Address is used as the destination address of the STP BPDU.
This command is used to designate the destination address of the STP BPDU in the service provider site.
It will only take effect on the VLAN trunk ports, which behave as the NNI ports in the service provider site.
This configuration will take effect for all the spanning-tree modes.
Example
This example shows how to configure using the dot1ad address as the destination address of the BPDU
on the VLAN trunk port.
Switch# configure terminal
Switch(config)# spanning-tree nni-bpdu-address dot1ad
Switch(config)#
00-00) as the destination address of the STP BPDU.
Specifies to use Provider Bridge Group Address (01-80-C2-00-00-08)
as the destination address of the STP BPDU.
1259