D-Link DXS-3600 Series Cli Reference Manual page 1040

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only takes effect when the interface is PIM-SM enabled.
In the DM mode, the DR priority option will not be carried in the Hello message. The router with the
highest priority value will be the DR. If multiple routers are with the same priority status, the router with the
highest IP address will be the DR. If there is a router that does not support the DR priority in its Hello
message on the LAN, all routers on the LAN will ignore DR priority and only use IP address to elect DR.
Example
This example shows how to configure the DR priority of the VLAN 1 interface to 200.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip pim dr-priority 200
Switch(config-if)#
83-5 ip pim jp-timer
This command is used to configure the Join/Prune interval value. Use the no form of the command to
restore the default setting.
ip pim jp-timer SECONDS
no ip pim jp-timer
Parameters
SECONDS
Default
By default, this value is 60 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only takes effect when the interface is PIM-SM enabled.
When configuring the Join/Prune interval, consider the factors, such as the configured bandwidth and
expected average number of multicast route entries for the attached network or link. For the SM-mode,
routers will periodically send join messages based on this interval. The hold-time in a Join/Prune
message is 3.5 times the join-prune-interval. The receiving router will start a timer based on this hold-time,
and prune the interface if no join message was received on this interface.
Example
Specifies the interval between Join/Prune messages. The range is
from 1 to 18000.
1035