Ip Ssh Server - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
Use this command to configure the SSH server parameters on the switch. The authentication retry
number specifies the maximum number of retry attempts before the session is closed.
Example
This example shows how to configure the SSH timeout value to 160 seconds.
Switch# configure terminal
Switch(config)# ip ssh timeout 160
Switch(config)#
This example shows how to configure the SSH authentication retries value to 2 times. The connection
fails after 2 retry attempt fails.
Switch# configure terminal
Switch(config)# ip ssh authentication-retries 2
Switch(config)#

97-4 ip ssh server

This command is used to enable the SSH server function. Use the no command to disable the SSH
server function.
ip ssh server
no ip ssh server
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable the SSH server function.
Example
This example shows how to enable the SSH server function.
Switch# configure terminal
Switch(config)# ip ssh server
Switch(config)#
97-5 ip ssh service-port
1189